Made from 3/16 STEEL
The factory prop shaft crossmember is known to bend. When the crossmember bends, it
changes the prop shaft angle and can lead to premature bearing failure and vibrations.
Our crossmembers are 2.5x thicker and add strength where it is needed.
Works with factory or aftermarket bearing carriers.
Bolts in using factory hardware
FITMENT:
2020-CURRENT PRO XP/ TURBO R 4 SEAT REAR
Customer Reviews
Based on 1 review
0%
(0)
100%
(1)
0%
(0)
0%
(0)
0%
(0)
R
This was what i was looking for cost was fair. Shipping was fast. It should have been a bolt in process but was not I had to modify it to fit there are 2 bolt holes on each side that bolt to frame but 1 side has a slot in it to fit over a tab that hangs down off of frame that would not fit over. I had to notch cross member to fit about a 1/4 inch. Other than that its a nice add on part that will do as described.
Customer Reviews
Based on 1 review
0%
(0)
100%
(1)
0%
(0)
0%
(0)
0%
(0)
R
This was what i was looking for cost was fair. Shipping was fast. It should have been a bolt in process but was not I had to modify it to fit there are 2 bolt holes on each side that bolt to frame but 1 side has a slot in it to fit over a tab that hangs down off of frame that would not fit over. I had to notch cross member to fit about a 1/4 inch. Other than that its a nice add on part that will do as described.
